Man page of RANDPKT

RANDPKT

Section: The Wireshark Network Analyzer (1)
Updated: 2011-07-18
Index of this MAN page

Back To MAN Pages From BackTrack 5 R1 Master List

NAME

randpkt - Random Packet Generator

SYNOPSIS

randpkt [ -b <maxbytes> ] [ -c <count> ] [ -t <type> ] <filename>

DESCRIPTION

randpkt is a small utility that creates a libpcap trace file full of random packets.

By creating many randomized packets of a certain type, you can test packet sniffers to see how well they handle malformed packets. The sniffer can never trust the data that it sees in the packet because you can always sniff a very bad packet that conforms to no standard. randpkt produces very bad packets.

When creating packets of a certain type, randpkt uses a sample packet that is stored internally to randpkt. It uses this as the starting point for your random packets, and then adds extra random bytes to the end of this sample packet.

For example, if you choose to create random ARP packets, randpkt will create a packet which contains a predetermined Ethernet II header, with the Type field set to ARP. After the Ethernet II header, it will put a random number of bytes with random values.

OPTIONS

-b <maxbytes>: Default 5000.
Defines the maximum number of bytes added to the sample packet. If you choose a maxbytes value that is less than the size of the sample packet, then your packets would contain only the sample packet... not much variance there! randpkt exits on that condition.
-c <count>: Default 1000.
Defines the number of packets to generate.
-t <type>: Default Ethernet II frame.
Defines the type of packet to generate:
        arp     Address Resolution Protocol
        bgp     Border Gateway Protocol
        bvlc    BACnet Virtual Link Control
        dns     Domain Name Service
        eth     Ethernet
        fddi    Fiber Distributed Data Interface
        giop    General Inter-ORB Protocol
        icmp    Internet Control Message Protocol
        ip      Internet Protocol
        llc     Logical Link Control
        m2m     WiMAX M2M Encapsulation Protocol
        megaco  MEGACO
        nbns    NetBIOS-over-TCP Name Service
        ncp2222 NetWare Core Protocol
        sctp    Stream Control Transmission Protocol
        syslog  Syslog message
        tds     TDS NetLib
        tcp     Transmission Control Protocol
        tr      Token-Ring
        udp     User Datagram Protocol
        usb     Universal Serial Bus
        usb-linux       Universal Serial Bus with Linux specific header

EXAMPLES

To see a description of the randpkt options use:

    randpkt

To generate a capture file with 1000 DNS packets use:

    randpkt -b 500 -t dns rand_dns.pcap

To generate a small capture file with just a single LLC frame use:

    randpkt -b 100 -c 1 -t llc single_llc.pcap

This document was created by man2html, using the manual pages.
Time: 07:34:21 GMT, September 13, 2011

If you would like to republish one of the articles from this site on your webpage or print journal please contact IronGeek.